Home > How to Assemble, Wear, and Care for Your e-BeltPouch

How to Assemble, Wear, and Care for Your e-BeltPouch

How to Assemble

  • 1) Decide which side you would like to wear your case on (right or left). If right, the d-rings (plastic "D" shaped rings on back of case) should be on the left side of the case.
  • 2) Lay the e-Pouch case down flat on a table with the d-rings facing up. Make sure the d-rings are facing out - not under case.
  • 3) Unsnap an e-BeltSnap (both snaps, top and bottom).
  • 4) Insert the bottom (has the two snaps) of the e-BeltSnap under and up through a d-ring so the d-ring sits between the fold and the snap.
  • 5) Snap the bottom snap into the middle snap so it wraps the d-ring.

How to Wear

To attach your e-BeltPouch to your belt

  • 1) Pick up the case and place it against your body below your belt (front facing out).
  • 2) Run the straps under (from bottom up) and over your belt.
  • 3) Snap closed around your belt.

To remove your e-BeltPouch

  • 1) Unsnap the top snap on the e-BeltSnap strap.
  • 2) Slide the e-BeltPouch down (so the straps slide under your belt).

Moving or adding an e-Pouch case

Each e-Pouch case is designed to be ambidextrous so you can use them on either side of your body. This means if you want your cell phone on your left side it's easy, just move it. Also each e-Pouch case has the ability to have another e-Pouch case added to it so that you can wear up to two e-Pouch cases per side at one time (you can try more, we recommend two per side). You can also wear your e-Pouch case with an e-Harness for both shoulders, or an e-ShoulderStrap for one shoulder (purchased separately).

Moving an e-Pouch case

  • 1) Unsnap the leather d-rings straps on the back of the e-Pouch case.
  • 2) Move the d-rings (with e-BeltSnaps) to the opposite d-ring straps and flip over so opening is facing to the front.
  • 3) Snap the straps closed over the d-rings.
  • 4) Run the straps under and over your belt.
  • 5) Snap closed over your belt.

Adding an e-Pouch Case

  • 1) Unsnap the leather d-rings straps on the back of the e-Pouch case.
  • 2) Place the bottom leather d-ring straps through the d-rings of the new e-Pouch case that you're adding (be sure the new e-Pouch case is facing the same direction as the existing e-Pouch case - be sure opening is facing the same way).
  • 3) Snap the leather d-ring straps closed.

How To Care

Care of either the leather or ballistic nylon e-BeltPouch is very minimal, in fact very much like the care you will provide to a wallet, purse, belt or other personal accessory. If your e-Pouch case or e-BeltSnap should become soiled the case can merely be wiped off with a damp cloth then allowed to air dry.

For the leather cases, if needed, acquire a good quality saddle soap and follow the package directions for its use. Never force the drying of the e-Pouch cases or the e-BeltSnap by exposing to heat, etc. Let them dry naturally, perhaps with a fan blowing across them. Heat can cause leather to shrink, crack, etc., just as with a fine pair of shoes or boots.